Water pressure too low, too high or weak flow: check it step by step

Safety look

Before any reading: is anything like this on site?

A gas smell at a heater, an appliance, gas piping or anywhere on site
Water reaching a panel, an outlet or powered equipment, or standing around a powered heater or pump
Someone in water near a running pump, or water on the controls of a well pump, booster or tank switch
Sewage on surfaces or electrical parts, or something toxic or caustic that may be in the drinking water
Water running that cannot be stopped at a fixture stop, a branch valve or the main
A ceiling or floor sagging, bulging or holding water, or framing that looks damaged near a wet area
A relief valve or its pipe capped or plugged on a working heater or boiler
A carbon monoxide alarm, or exhaust spilling or soot at a gas or oil appliance

Taken as what you could see, not as a finding that none of these are present.

What decides which causes can apply

0 of 2

Which causes can apply depends on where the water comes from.

Nothing on this page is saved anywhere: the answers live in its address. General guidance for a qualified person, not a finding about any home. The person on site decides.

Water pressure too low, too high or weak flow.

Safety look

What decides which causes can apply