Skip to content
forebot.
Sign inBook a demo

Clean up, label, and hand it back.

Reach for this before you tell the customer the job is done.

A detector left off, a missing label, or a skipped explanation can hurt someone or bring you back.

Run it on a job in ForeBotAll checklists

Step by step

7

  1. Reverse every temporary change

    Remove seals, tape, plastic, and return covers. Put dampers, doors, fans, and settings back as you found them.

    Write down · Note

  2. Put alarms and detection back

    Put back and test smoke and carbon monoxide alarms. Turn detection back on. Tell the fire department if it was notified.

    Write down · Note

  3. Leave gas restores to a qualified person

    A qualified gas technician restores gas valves and relights pilots. Record who did it and when.

    Write down · Note

  4. Label what the next person needs

    Mark shutoffs, breakers, access points, and anything an owner must not switch off. Photograph each label.

    Write down · Photo

  5. State what is temporary

    List any temporary fix plainly, the repair still owed, and when it gets rechecked. Do not call it repaired.

    Write down · Note

  6. Walk the customer through it

    Give a short procedure they can use, plus the checks they must make. Leave guides named by revision.

    Write down · Note

  7. Book the follow-up

    Open the follow-up task before you leave so the job does not close with nothing scheduled.

    Write down · Task
Done when

A finished run leaves a put-back list, label photos, the customer's instructions, open items, and a scheduled follow-up.

General guidance for a qualified person, not a finding about any home. The person on site decides.